Removing cover of toothed belt for coolant pump: Audi A4 B9 (CVNA)

🧭 Before you start

Fits: Audi A4 B9 (8W, 2015–)

• Renewed: o-rings

Don't miss

• Renew O-rings after removing.

🔧 Engine codes this applies to

📋 Procedure

1. Remove engine cover panel .
2. Take electrical connectors (1, 2) for Lambda probes out of bracket, unplug them and move electrical wiring clear.
3. Remove bolt (2) and move fuel line (1) clear.
4. Move hose (4) for activated charcoal filter system clear along with coolant line (6).
5. Unplug electrical connector (5) at charge pressure sender G31.

6. Release fasteners (arrows) and detach air pipe (3).
7. Press release tabs on both sides and disconnect hose (2) leading to activated charcoal filter.
8. Remove bolts (arrows), detach crankcase breather hose (1) and move it towards rear.
9. Unscrew bolts (arrows) and remove cover (1) for toothed belt for coolant pump and bracket (2). [Note: Renew O-rings after removing.]
10. Install engine cover panel .

Other AUDI procedures

• Removing and installing engine support (left-side) – Audi
• Removing and installing exhaust camshaft oil seal, pulley end
• Removing and installing engine support (right-side) – Audi
• Installing fuel tank - all vehicles – Audi A4 B9
• Removing and installing toothed belt cover (centre)
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures