Removing and installing coolant pump, vehicles with fully enclosing toothed belt guard — AUDI

🧭 Before you start

Fits: platform codes S1, 2H

• Opens: coolant
• Renewed: o-ring

Don't miss

• Always renew O-ring.

🔧 Engine codes this applies to

📐 25 workshop diagrams for CDBA

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. Remove underbody guard, if fitted General body repairs, exterior66Underbody guard.
2. Remove lower toothed belt guard (fully enclosing) .
3. Remove toothed belt from coolant pump .
4. Drain coolant .
5. Remove insert for coolant pump (2).

6. Unscrew bolts (4).
7. Unscrew stud (3).
8. Remove coolant pump (1). [Note: Always renew O-ring.]
9. Install toothed belt .
10. Install lower toothed belt guard .
11. Replenish coolant .
12. Install underbody guard, if fitted previously General body repairs, exterior66Underbody guard.

Other AUDI procedures

• Checking engine oil cooler for leaks
• Measuring radial play of camshaft – Audi 2.0 TDI · 1 torque figures
• Removing and installing air filter housing – Audi 2.0 TDI
• Assembly overview - poly V-belt drive · 1 torque figures
• Removing and installing high-pressure accumulator (rail)
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures