Removing and installing engine support (left-side) — AUDI

🧭 Before you start

Fits: Audi A4 B9 (8W, 2015–)

Don't miss

• Shown in illustration with engine removed.

🔧 Engine codes this applies to

📋 Procedure

1. Remove engine cover panel .
2. Lift retaining clip (3), disconnect coolant hose and move it clear.
3. Unplug electrical connector (1) for coolant shortage indicator switch F66.
4. Remove bolt (4) and push coolant expansion tank (2) to one side.
5. Unscrew bolt (arrow) and press coolant pipes (1) slightly to one side.

6. Move electrical wiring harness clear at retaining clip (arrow).
7. Remove top bolts (2) for engine support.
8. Detach poly V-belt from air conditioner compressor pulley Removing and installing poly V-belt.
9. Remove air conditioner compressor from bracket Heating, air conditioning87Air conditioner compressor; Detaching and attaching air conditioner compressor at bracket.
10. Remove engine mounting (left-side) .
11. Unscrew bottom bolts (1, 3) and detach engine support (left-side). [Note: Shown in illustration with engine removed.] [Note: After removing, renew bolts tightened with specified tightening angle.]
12. Connect coolant hose with plug-in connector .
13. Install poly V-belt .
14. Install engine cover panel .

Other AUDI procedures

• Removing and installing engine support (right-side)
• Installing fuel tank - all vehicles
• Checking fuel system pressurisation pump G6 - TFSI vehicles
• Removing and installing stage 3 oil pressure switch F447
• Removing and installing fuel pressure sender for low pressure G410
• Removing and installing toothed belt · 56 torque figures
• Removing engine · 41 torque figures
• Removing camshaft timing chain from camshafts · 38 torque figures
• Installing engine · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures