Removing and installing wind deflector: Audi A1
Step-by-step removing and installing wind deflector for the Audi A1: 11 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A1 (8X, 2010–2018)
Don't miss
- The moulding must make contact with the stop; otherwise it will be distorted when it is pressed into the surround frame.
- Press the complete moulding evenly into the surround frame (moulding must not be wavy).
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 2 Nm (1.5 lb-ft) | When installing, tighten bolts |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Open sliding sunroof fully.
- Press wind deflector (1) down and pull moulding (2) out of surround frame at edges.
- Keep pressing wind deflector down and pull moulding (1) out of surround frame and upwards off retaining tabs.
- Remove bolts (left and right) from bearing.
- Pull wind deflector forwards out of mounting and lift off.
- Insert spring (1) in wind deflector.
- Slide wind deflector with spring (1) towards rear into mounting.
- Screw in bolts (2) and tighten to specified torque.
- Align moulding (1) centrally or so that it makes contact with stop (arrow). [Note: The moulding must make contact with the stop; otherwise it will be distorted when it is pressed into the surround frame.]
- Carefully press moulding (1) into surround frame (2). [Note: Press the complete moulding evenly into the surround frame (moulding must not be wavy).]
- Press moulding (1) into retaining tabs (arrows) of surround frame (2) using an assembly wedge.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing cover for memory switch unit – Audi · 1 torque figures
- Removing and installing seat adjustment switch - seat with seat memory/electric adjustment · 1 torque figures
- Removing and installing seat rake adjustment motor - seat with seat memory/electric adjustment · 1 torque figures
- Removing and installing trim panel for rear fog light and number plate light
- Running gear, front-wheel drive and four-wheel drive — Wheel bearing: exploded view · 1 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.