Removing and installing washer fluid reservoir - vehicles without auxiliary heater — AUDI

🧭 Before you start

Fits: Audi A3 (8P, 2003–2012)

📋 Procedure

1. Switch off ignition and take out ignition key.
2. Remove filler neck for washer fluid reservoir .
3. Remove front section of front right wheel housing liner 66.
4. Remove fog light .
5. Place drip tray under washer fluid reservoir.

6. Unplug electrical connector (5).
7. Detach wiring harness (4) from retainer on washer fluid reservoir.
8. Release retaining clip (6)(right arrow) and pull washer fluid hose (7) off washer pump.
9. Unplug electrical connector (3).
10. Release retaining clip (2)(left arrow) and pull washer fluid hose (1) off headlight washer system pump.
11. Remove bolt (3).
12. Unscrew nuts (1) and detach washer fluid reservoir (2).
13. Install fog light .
14. Install front section of front right wheel housing liner 66.
15. Install filler neck for washer fluid reservoir .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing steering angle sender G85 – Audi A3
• Overview of fitting locations - hydraulic power steering (vehicles with 6-cylinder TFSI engine, vehicles with/without dynamic steering)
• Renewing oil seal for rear splined shaft - rear splined shaft with vibration damper
• Removing and installing heater coolant shut-off valve – Audi
• Renewing brake disc