Removing and installing washer fluid reservoir, vehicles with auxiliary heater — AUDI

🧭 Before you start

Fits: VW Caddy III (2K, 2004–2015); platform code 2C0

📋 Procedure

1. Switch off ignition and all electrical loads, and pull out ignition key.
2. Remove filler pipe for washer fluid reservoir .
3. Remove front bumper cover General body repairs, exterior63Front bumper, up to 2011 or General body repairs, exterior63Front bumper, as of 2011.
4. Remove right headlight .
5. Pull hose connections (1) off windscreen and rear window washer pump and use a suitable container to collect the washing fluid that comes out.

6. Unclip fastener (1) from wiring harness.
7. Push window washer pump upwards in (direction of arrow) and remove.
8. Unclip fasteners (1) and (2) from wiring harness.
9. Unclip fuel line of auxiliary heater from retainer (1).
10. Unclip fuel line from retainers (1) and (2).
11. Unscrew securing bolts (1) and (2).
12. Pull washer fluid reservoir towards front out of mountings.
13. On completion of installation work, bleed headlight washer system .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures