Removing and installing washer fluid reservoir (vehicles with no auxiliary heater) — VW

🧭 Before you start

Fits: platform code 1F7

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Pull connecting pipe (1) off filler neck (3) on washer fluid reservoir.
2. Remove securing bolt (2).
3. Unclip hose retainer from filler neck (3) and remove filler neck (3) from vehicle.
4. Switch off ignition and all electrical consumers and remove ignition key.
5. Remove front bumper cover General body repairs, exterior63Removing and installing front bumper cover. [Note: The connections at the pump and hoses are colour coded to prevent interchanging the washer fluid lines to the windscreen and rear window washer pump V5. The hose connections must be connected to the correct colour-coded pump connections during installation.]

6. To release, turn securing clips at hose connections (3) and (5) and pull these off washer pump V5(4).
7. Drain any escaping fluid in a suitable container.
8. Disconnect connector (6) for windscreen washer fluid level sender G33(7).
9. Unclip wiring harness.
10. Pull windscreen washer pump V5(4) upwards out of reservoir and separate connector (2).
11. Pull headlight washer pump V11(9) upwards out of reservoir and disconnect connector (10).
12. Unscrew securing bolts (arrows) from reservoir and remove reservoir, together with connecting pipe for filler neck, from vehicle.
13. Tighten all threaded connections (arrows) to 8 Nm torque. — 8 Nm (5.9 lb-ft)
14. Tighten securing bolt (2) to 2.5 Nm. — 2.5 Nm (1.8 lb-ft)
15. Clip in hose retainer from filler neck (3).
16. Install front bumper cover General body repairs, exterior63Removing and installing front bumper cover.
17. Top up fluid for windscreen and headlight washer system.
18. On completion of installation work, bleed headlight washer system .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Allocation gearbox - engine, vehicles as of model year 2011
• Removing and installing outer constant velocity joint of drive shafts »VL100« and »VL107«
• Assembly overview - rear wheel suspension
• Removing and installing hydraulic steering rack
• Removing and installing steering rack, 3rd generation, RHD vehicles, as of model year 2009