Removing and installing upper transverse link (four-wheel drive) — AUDI

🧭 Before you start

Fits: Audi TT Mk2 (8J, 2006–2014)

Don't miss

• Use felt-tip pen or similar to mark position of eccentric bolt (arrow) in relation to subframe.
• Install bolt (3) with washer (4) (washer MUST be fitted).
• Note mark for position of eccentric bolt (arrow) in relation to subframe.

📋 Procedure

1. Measure distance from centre of wheel to lower edge of wheel housing .
2. Remove wheel.
3. Remove coil spring .
4. Detach wiring (1) completely from bracket (2).
5. Unscrew nut (6) and take off washer (5).

6. Remove bolt (3) and take off washer (4).
7. Use felt-tip pen or similar to mark position of eccentric bolt (arrow) in relation to subframe.
8. Remove bolt (arrow).
9. Take out upper transverse link.
10. Install bolt (3) with washer (4) (washer MUST be fitted).
11. Note mark for position of eccentric bolt (arrow) in relation to subframe.
12. Check and adjust wheel alignment as required, see chart .

🎬 Related video tutorial

Independent AUTODOC tutorial for the same job, filmed on a different model (A3 2 (8PA)) — the technique carries over, the fasteners and figures on this page are the ones for your car.

How to change front suspension arm / front control arm on AUDI A3 2 (8PA)

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing sump – Audi · 10 torque figures
• Adjusting rear lid · 12 torque figures
• Removing and installing dash panel, Multivan, Comfort version · 10 torque figures
• Dismantling and assembling gearbox · 9 torque figures
• Installing bevel box – Audi A3 · 11 torque figures