TorqFix

Removing and installing trim (sill side) - standard seat, convenience seat, sports seat with electric adjustment — AUDI

Removing and installing trim (sill side) - standard seat, convenience seat, sports seat with electric adjustment on Audi: 11 steps.

Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.

11 steps

🧭 Before you start

Fits: Audi Q5 (8R, 2008–2017); platform code 83

📋 Procedure

  1. Move front seat upwards as far as it will go.
  2. Unscrew bolt (5) and remove fastener (4) for seat side trim.
  3. Disengage seat side trim (rear) (1) from seat (arrow A).
  4. Unfasten clip (2) at seat side trim and disengage retaining bracket (3). To do so, carefully pull trim away from front seat slightly.
  5. Unfasten catch (arrow) between storage compartment (2) and seat side trim (sill side) (1).
AUDI? Steps differ between engine variants — check this job against your exact car before you commit to it. Check my car — free →
  1. Disengage seat side trim from retaining bracket and detach towards front.
  2. Unplug connector (4) at lumbar support adjustment switch (3).
  3. Unplug connectors (1, 5) at seat adjustment operating unit (2).
  4. Detach seat side trim (sill side).
  5. Unscrew bolts (1, 2, 4).
  6. Detach retaining bracket (3) from front seat. When doing so, detach any cable ties from retaining bracket. [Note: Make sure electrical connectors are fitted correctly (as far as stop) and engage audibly.Make sure seat side trim (sill side) is properly engaged at retaining bracket and that lockable clip is fastened.Make sure wiring is as close as possible to connectors (1, 4, 5).]

Who makes these pages, and how

TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.

The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.

Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.

Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com

The story behind TorqFix →

Workshop data on this page last updated 20 Sep 2026.