Removing and installing three-point seat belt (rear) in rear seat backrest — AUDI

🧭 Before you start

Fits: Audi A6/A7 C7 (4G, 2011–2018); platform code 4X

Don't miss

• Make sure electrical connectors are fitted correctly (as far as stop) and engage audibly.Make sure that wiring is not trapped.

📋 Procedure

1. Remove rear seat bench .
2. Remove 2/3 section (right-side) of split rear seat backrest .
3. Remove backrest cover with backrest padding for rear seat bench .
4. ⚠ Observe safety regulations for pyrotechnic components .Observe disposal regulations for pyrotechnic components .Before handling pyrotechnic components (e.g. unplugging the electrical connector) the mechanic must discharge any static electricity. This can be done by briefly touching the door striker plate, or similar. — Unplug electrical connector (4).
5. To do so, use a small screwdriver (1) to release connector locking element (3) and unplug electrical connector (2).

6. Unscrew nut (1).
7. Disengage three-point seat belt (2) and detach.
8. Thread out belt (3).
9. If components of the belt system are removed following an accident, renew the securing bolts for the belt system.
10. Insert three-point seat belt with locating element (1) in mounting (2)(arrow) and tighten nut. [Note: Make sure electrical connectors are fitted correctly (as far as stop) and engage audibly.Make sure that wiring is not trapped.]
11. ⚠ When working on a vehicle with the ignition switched on or while the drive system is active, the engine can start unexpectedly and exhaust fumes can cause a health hazard in closed rooms. Moving parts can trap or draw in parts of the body and/or clothing (safety hazard). Before switching on the ignition, perform the following steps:Move selector lever to position PActivate parking brake Switch off ignitionOpen bonnetConnect battery charger (e.g. VAS 5095A) to jump-start connections of 12 V electrical system. Switch on ignition — With ignition switched on, connect battery earth wire Electrical system27Battery; Disconnecting and connecting battery.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Servicing refrigerant circuit
• Renewing oil seal for selector shaft – Audi A6 C6 · 1 torque figures
• Removing and installing poly V-belts – Audi · 2 torque figures
• Checking charge pressure control solenoid valve N75 – Audi
• Checking secondary air inlet valve N112 – Audi TT Mk1