Removing and installing three-point seat belt, 1st row — AUDI

🧭 Before you start

Fits: VW Caddy IV (SA, 2015–2020)

Don't miss

• On vehicles with sliding door, ensure after installing that the seat belt strap runs above the belt guide (6).

📋 Procedure

1. Remove C-pillar trim .
2. If fitted, unclip cover from fasteners (arrows) using wedge T10039/1.
3. Detach sill panel moulding from mountings in area of belt end anchor (2).
4. Remove bolt (1).
5. Remove belt end anchor (2).

6. Remove bolt (3).
7. Remove belt inertia reel (4) from C-pillar.
8. Remove bolt (7).
9. Remove belt guide fitting (6).
10. Fold up cap (8).
11. Remove bolt (9).
12. Remove belt guide fitting (10) and washer (11). [Note: On vehicles with sliding door, ensure after installing that the seat belt strap runs above the belt guide (6).]

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing gearbox, engine lifting eyes »diagonally« on engine
• Removing and installing mechatronic unit for dual clutch gearbox J743, gearbox installed
• Removing gearbox, vehicles with petrol engine
• Separating cover and padding, Multivan
• Separating cover and padding, Transporter