Removing and installing telephone/navigation system loudspeaker R39 — AUDI

🧭 Before you start

Fits: Audi TT Mk1 (8N)

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Switch off all electrical consumers.
2. Remove ignition key.
3. Windscreen defroster vent (1) cannot be removed without destroying it.
4. Pull defroster vent (1) upwards starting at front.
5. In doing so, break off retainer tab (2).

6. Use pliers to extract retainer tab (2).
7. Slacken off bolts (2) (2 Nm) at hands-free loudspeaker (3). — 2 Nm (1.5 lb-ft)
8. Take loudspeaker out of insert and unplug connector (4).
9. Installation is performed in reverse sequence.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing retaining plate with defroster flap control motor V107, left side vent control motor V299 (and left centre vent control motor V110)
• Removing and installing hydraulic fluid cooler (all vehicles except V12 TDI engine) · 1 torque figures
• Removing and installing belt height adjuster (front) – Audi Q7 · 1 torque figures
• Removing and installing outer three-point seat belt (2nd row)
• Removing and installing refrigerator box J698