Removing and installing bracket for navigation system with CD drive control unit J401 — AUDI

🧭 Before you start

Fits: Audi Q7 (4L, 2005–2015)

📋 Procedure

1. Switch off ignition and all electrical equipment and remove ignition key.
2. Remove luggage compartment side trim (right-side) General body repairs, interior70Trim; Removing and installing luggage compartment side trim.
3. Unclip trailer detector control unit J345(1) and swivel aside.
4. Remove bolt (2).
5. Unscrew nuts (arrows).

6. If fitted, remove adaptive suspension control unit J197.
7. Unplug all connectors to navigation system with CD drive control unit J401.
8. Fit protective cap for cable connectorVAS 6223/9(1) onto MOST bus connector (2).
9. Remove bracket.
10. Installation is performed in reverse sequence.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Adjusting vacuum unit for turbocharger, engines with code letters AXX, BPY, BWA
• Removing and installing thermostat housing and coolant pipe (rear)
• Removing and installing alternator - vehicles with 1.6 ltr. TDI engine
• Removing and installing engine support – Audi 1.6 TDI
• Removing and installing gearbox mounting – Audi TT Mk1 1.2