Removing and installing radio, telephone and navigation system aerial R52 — AUDI

🧭 Before you start

Fits: Audi Q7 (4L, 2005–2015)

Don't miss

• Make sure that the radio, telephone and navigation system aerial R52(1) is fitted level on the roof.

📋 Procedure

1. Switch off all electrical equipment.
2. Remove ignition key.
3. Remove luggage compartment side trim (right-side) General body repairs, interior70Trim.
4. Remove D-pillar trim (right-side) General body repairs, interior70Trim.
5. Pull down moulded headliner (rear) General body repairs, interior70Trim.

6. Unplug connectors (4) and (5) of aerial wires (3) in retainer.
7. Unclip aerial wires (arrows) going to satellite radio R146.
8. Unscrew nut (2).
9. Lift radio, telephone and navigation system aerial R52(1) off roof.
10. Guide in the aerial wiring (3) and carefully fit the radio, telephone and navigation system aerial R52(1) onto the roof.
11. Make sure that the radio, telephone and navigation system aerial R52(1) is fitted level on the roof.
12. Secure aerial wiring with adhesive tape and clip aerial wiring (4) and (5) into retainer.
13. Plug in connectors.
14. Perform further installation in reverse sequence.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing door lock up to Model Year 2005 – Audi
• 5 and 6-speed manual gearbox 01E, front-wheel drive — Dismantling and assembling input shaft
• 6-speed manual gearbox 01E, four-wheel drive — Renewing oil seal for flange shaft
• Removing and installing water radiator for fuel cooling system - vehicles with engine code letters AJM
• Dismantling and assembling input shaft - gearboxes from approx. 04.2003