Removing and installing tail light cluster and outer bulb carrier — AUDI

🧭 Before you start

Fits: Audi A6 C6 (4F, 2004–2011)

• Renewed: adjuster nut

Don't miss

• Renew adjuster nut if sealing washer is damaged.

📋 Procedure

1. Switch off ignition and take out ignition key.
2. Turn light switch to position "“0”".
3. Remove cover on luggage compartment side trim.
4. Unscrew cap nut (2).
5. Pry tail light cluster (1) at outer edge out of clip nuts using removal wedge3409.

6. Remove tail light cluster from body opening.
7. Unplug electrical connector at bulb carrier.
8. Press apart retaining tabs (arrows) and take bulb carrier (1) out of tail light cluster.
9. Screw bulb out of bulb holder. [Note: Renew adjuster nut if sealing washer is damaged.]
10. Fit tail light cluster in position on body and press retaining pins into clip nuts.
11. Tighten cap nut.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing servotronic solenoid valve N119 – Audi · 1 torque figures
• Checking delivery pressure of power steering pump (vehicles with 8-cylinder FSI engine, vehicles with and without dynamic steering)
• Removing camshafts and re-installing used camshafts - cylinder bank 1 (right-side)
• Removing and installing temperature flap control motor V68/rear temperature flap control motor V137
• Removing and installing heater housing (left-side, with temperature flaps)