Removing and installing outer rear light and bulb carrier (Avant) — AUDI

🧭 Before you start

Fits: Audi A4 B6/B7 (8E)

Don't miss

• Ensure that seal between body and rear light housing seals completely.

📋 Procedure

1. Switch off ignition and take out ignition key.
2. Turn light switch to position "“0”".
3. Unclip plug (1) from luggage compartment trim (arrow) using a screwdriver.
4. Remove bolt (2).
5. Swivel rear light (1) outwards (arrow), and at the same time disengage retaining pins from body.

6. Unplug electrical connector at bulb carrier.
7. Press apart retaining tabs (arrows) and take bulb carrier (1) out of rear light.
8. Turn bulbs to remove them from their holders. [Note: Ensure that seal between body and rear light housing seals completely.]
9. Fit rear light in position on body and press retaining pins into holes.
10. Tighten bolt.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing subframe without steering rack (vehicles without high-voltage system)
• Renewing bonded rubber bush for wheel bearing housing – Audi
• Removing and installing trailing arm with mounting bracket
• Removing and installing silencer – Audi 4.2
• Removing and installing wing panel – Audi A3 · 1 torque figures