Removing and installing table module in side panel — AUDI

🧭 Before you start

Fits: VW Transporter T5 (7H), VW Transporter T5 (7J), VW Transporter T6 (7E), VW Transporter T6 (7F)

📋 Procedure

1. Remove upper B-pillar trim .
2. Remove upper C-pillar trim .
3. Remove upper D-pillar trim .
4. Remove trim panel on rear side panel trim .
5. Remove rear ashtray together with mounting frame .

6. Remove rear side panel trim .
7. Remove front side panel trim .
8. Disconnect connector for table module (arrow).
9. Unscrew bolts (4) and remove assembly plate (3).
10. Unscrew bolts (1) and remove table module (2) from side board. [Note: All cable ties and insulation materials that were loosened or cut during removal must be installed in the same position.Before installing side panel trim, ensure that retaining clip (arrow) is not fitted. Otherwise the table will not function correctly when unfolding it.All remaining retaining clips must be checked for damage and renewed if necessary before installing.]

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Exploded view - camshaft timing chains
• Removing and installing gear detection sensor G604
• General notes on front axle
• Removing and installing active steering safety lock actuator F437
• Exploded view - gearbox cover