Removing and installing switches in dash panel: Audi TT Mk1
Step-by-step removing and installing switches in dash panel for the Audi TT Mk1: 11 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi TT Mk1 (8N)
📋 Procedure
- Switch off ignition and take out ignition key.
- Remove radio 91.
- Pull down cover plate (1) in top of radio slot at opening (arrow) and take out of radio slot.
- Reach upwards through radio slot and release switches by pulling clip (1) downwards (arrow).
- Press switch forwards out of dash panel.
- Take switch out of dash panel through radio slot.
- Unplug electrical connector.
- Press clip upwards until it engages.
- Plug in electrical connector.
- Insert cover plate in top of radio slot.
- Install radio 91.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Separating seat pan cover and padding - seat pan without seat depth adjustment
- Removing and installing thermostat - vehicles with SCR catalytic converter
- Removing and installing coolant pipe (rear left) - engine codes CAMA, CAMB, CAPA
- Removing and installing high-pressure pump - engine codes CAMA, CAMB, CCWA, CCWB, CGKA, CGKB, CCLA
- Draining active tank for reducing agent
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.