Removing and installing static cornering light M51/M52, gas discharge headlights - vehicles from model year 2012 onwards, USA vehicles from model year 2013 onwards — AUDI
Removing and installing static cornering light M51/M52, gas discharge headlights - vehicles from model year 2012 onwards, USA vehicles from model year.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A5 (8T, 2007–2016)
Don't miss
- Do not flash the headlights.
- Plug electrical connector in again and push new bulb beyond resistance of spring clips into housing; do not touch glass part of bulb with bare hands.
📋 Procedure
- Turn light switch to position "“0”".
- Switch off ignition and all electrical equipment and remove ignition key.
- Do not flash the headlights.
- Audi A5, right-side: Remove air cleaner housing 23Air cleaner; Removing and installing air cleaner housing or 24Air cleaner; Removing and installing air cleaner housing.
- Pull housing cover (1) off headlight housing (arrow).
- Remove bulb (1) from spring clips (arrows).
- Unplug electrical connector (2) at bulb.
- Plug electrical connector in again and push new bulb beyond resistance of spring clips into housing; do not touch glass part of bulb with bare hands.
- Close housing cover.
- Audi A5, right-side: Install air cleaner housing 23Air cleaner; Removing and installing air cleaner housing or 24Air cleaner; Removing and installing air cleaner housing.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Emptying fuel tank, front-wheel drive, engine codes CAYD, CAYE, CFHC, CFHF, CLCA, CUUB, CUUC, CUUD, CUUE, CUUF
- Installing cover for gearbox housing and 5th gear
- Removing and installing brake caliper, floating caliper disc brake FN3
- Removing and installing rear brake cable, brake caliper FN 44
- Repairing inner constant velocity joint
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.