Removing and installing starter, 1.2 l injection engine, manual gearbox — AUDI

🧭 Before you start

Fits: VW Caddy III (2K, 2004–2015); platform code 2C0

📋 Procedure

1. ⚠ To disconnect and reconnect the battery, the procedure described in the workshop manual should be strictly adhered to . — Disconnect battery .
2. Remove air filter housing Engine24Injection system; Assembly overview - air filter.
3. Push protective caps off solenoid switch downwards in direction of (arrow).
4. Unbolt positive cable (1) and release and disconnect electrical connector of terminal 50 (2).
5. Unscrew and remove earth wire from upper starter bolt (arrow).

6. Undo upper starter bolt (arrow).
7. If fitted, remove noise insulation General body repairs, exterior66Noise insulation.
8. Undo nut (1) and remove it from lower securing bolt of starter.
9. Remove wire holder (2).
10. Undo lower starter bolt (arrow).
11. Remove starter by taking it downwards out of the vehicle.
12. Tighten threaded connections to specified torque given in assembly overview .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Exploded view - lock carrier with attachments · 2 torque figures
• Exploded view - oil filter housing/oil pressure switch · 3 torque figures
• Exploded view - ATF system · 3 torque figures
• 4-cylinder petrol engine · 3 torque figures
• Renew roof actuation hydraulic pump V118 · 2 torque figures