Exploded view - oil filter housing/oil pressure switch — AUDI
Exploded view - oil filter housing/oil pressure switch on Audi: 6 steps, 3 torque figures, engines CALB, CAUA, CBBB, CFFA.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi TT Mk2 (8J, 2006–2014)
Don't miss
- Renew the bolts tightened with specified tightening angle.
🔧 Engine codes this applies to
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 20 Nm (15 lb-ft) | Tighten oil pressure switch F1(item 1) |
| 22 Nm (16 lb-ft) | Tighten union nuts |
| 9 Nm (6.6 lb-ft) | Tighten bolt (1) |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Screw in union nuts by hand until they make contact.
- Tighten union nuts to 22 Nm. — 22 Nm (16 lb-ft)
- Secure bracket. [Note: Renew the bolts tightened with specified tightening angle.]
- Fit bolts at top left and bottom right first.
- Tighten bolts in 2 stages as follows:
- Fit seal (2) so it can be attached to all tabs on engine oil cooler (1).
Other AUDI procedures
- Installing engine - vehicles with automatic gearbox · 1 torque figures
- Measuring radial clearance of camshaft – Audi A6/A7 C7 · 6 torque figures
- Separating engine and gearbox - vehicles with manual gearbox · 4 torque figures
- Separating engine and gearbox - vehicles with automatic gearbox · 3 torque figures
- Removing and installing coolant pipe (right-side) – Audi · 1 torque figures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix → · How these pages are made →Workshop data on this page last updated 20 Sep 2026.