Removing and installing spoiler for rear lid - Avant, equipment version: S line — AUDI

🧭 Before you start

Fits: Audi A4 B6/B7 (8E)

📋 Procedure

1. Remove rear lid trim (top).
2. Remove high-level brake light.
3. Remove bolts .
4. Heat rear lid in bonding area from inside with hot air blowerV.A.G 1416.
5. Mask spoiler (1) and rear lid (2) in cutting area.

6. Attach wire for removal kitVAS 6452/2(item 3) on one side between spoiler (1) and rear lid (2).
7. Cut spoiler (1) clear as far as threaded pins (4).
8. Repeat procedure on opposite side.
9. Lever off spoiler (1) with a plastic wedge in area between threaded pins (arrows) and guide in wire for removal kitVAS 6452/2.
10. Cut area between threaded pins (arrow) clear and remove spoiler (1).
11. Remove any adhesive residue on rear lid and spoiler, and clean with cleaning solution D 009 401 04.
12. Attach spoiler attachment repair kit to spoiler.
13. Peel protective paper off double-sided adhesive tape.
14. Fit spoiler above holes.
15. Starting in centre and working outwards, press spoiler on across entire width.
16. Open rear lid and tighten bolts.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Exploded view - silencer on vehicles with front-wheel drive and torsion beam axle
• Removing and installing exhaust gas temperature sender 1 G235 - vehicles with engine codes CDUD, CPNB, CTBA and CTBC
• Removing and installing exhaust gas temperature sender 3 G495 - vehicles with engine codes CDUD, CPNB, CTBA and CTBC
• Removing and installing holder for rear air distribution flap control motor V427
• Expansion valve with refrigerant shut-off valve 2 for hybrid battery N517