Removing and installing side trim on tunnel side: Audi A8 D3

🧭 Before you start

Fits: Audi A8 D3 (4E, 2002–2010)

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Remove the seat pan .
2. Disengage the front trim (1) at the location marked with an arrow from the side trim on the tunnel side (3).
3. Unscrew the bolt (2). 2.5 Nm. — 2.5 Nm (1.8 lb-ft)
4. Prise out the fastening strip (4).
5. Pull off the side trim on the tunnel side (3) to the rear.
6. Install the side trim on the tunnel side (3) in the reverse order of removal.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Dismantling and assembling output shaft (pinion shaft) – Audi
• Checking continued coolant circulation pump V51 – Audi A6 C5
• Checking voltage supply for air mass meter – Audi A3 1.8
• Checking power assisted steering pressure switch F88
• Removing and installing cigarette lighter U1/electric socketU with function selection switch 2E272