Removing and installing side member trim for wing panel: Audi A3

🧭 Before you start

Fits: Audi A3 (8P, 2003–2012)

📋 Procedure

1. Detach side member trim in area of A-pillar .
2. Remove rear section of wheel housing liner (front) .
3. Remove expanding screws (1) and pull out fastener (2).
4. Carefully heat side member trim (3) with hot air blowerV.A.G 1416.
5. Release fasteners (arrows) and carefully prise side member trim off wing panel (4) using removal wedge3409.

6. Clean bonding surface on wing with cleaning solutionD 009 401 04.
7. Peel protective film off adhesive strip (3).
8. Fit side member trim (1) on wing panel (front), making sure that locating lugs (arrows) are pressed into mounting.
9. Press side member trim onto wing panel (front) (2).
10. Install rear section of wheel housing liner (front) .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Centralising camber at front wheels · 3 torque figures
• Audi 80/100 V6 14 V, AAH/ABC
• Exploded view: Pipes and hoses (vehicles with V6 TDI engine) · 3 torque figures
• Performing basic setting · 1 torque figures
• Finish balancer · 3 torque figures