Removing and installing shock absorbers (long wheelbase) — AUDI

🧭 Before you start

Fits: VW Caddy III (2K, 2004–2015); platform code 2C0

• Renewed: securing bolts

Don't miss

• Only use new securing bolts and securing nuts!

📋 Procedure

1. Raise vehicle.
2. Position engine and gearbox jackVAS 6931(1) under axle beam (2).
3. Secure axle beam with tensioning strap.
4. Raise axle beam (2) slightly using engine and gearbox jackVAS 6931(1).
5. Unscrew nut (2) of shock absorber threaded connection.

6. Remove bolt (1).
7. Guide shock absorber (5) out of rear axle mounting.
8. Unscrew upper nut (4).
9. Remove bolt (3).
10. Remove shock absorber (5). [Note: Only use new securing bolts and securing nuts!]

🎬 Related video tutorial

Independent AUTODOC tutorial for the same job, filmed on a different model (80 B4) — the technique carries over, the fasteners and figures on this page are the ones for your car.

How to change rear shock absorbers on AUDI 80 B4 TUTORIAL

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing spray jets - vehicles up to Model Year 2002
• Removing and installing front seat heating switches – Audi A2
• 6-speed manual gearbox 01E/0A1, front-wheel drive — Dismantling and assembling input shaft
• Removing and installing inlet camshaft control valve 1N205
• Adjusting locking cable on vehicles with vehicle ID No. from 8E_8A 002700 onwards