Removing and installing spray jets - vehicles up to Model Year 2002 — AUDI

🧭 Before you start

Fits: Audi A2 (8Z)

📋 Procedure

1. Remove the wiper arm .
2. Detach washer fluid pipe (3).
3. If fitted, detach electrical connectors (4) and (5) for heated washer jets.
4. Release hose clamp (6) with hose clamp fitting toolV.A.G 1921 and detach water drain hose from cowl panel grille.
5. Detach rubber seal (1) for cowl panel grille.

6. ⚠ To stop the cowl panel grille (2) being torn on removal, apply a small quantity of soap solution to the transition between the windscreen and cowl panel grille and pull the cowl panel grille vertically upwards out of the fastening strip, starting at the edge of the windscreen. — Detach the cowl panel grille (2).
7. Set the washer fluid pipe aside.
8. Lay wiring to relevant spray jet aside.
9. Detach washer fluid pipe from relevant spray jet.
10. Press back both retaining tabs using a screwdriver (arrow 1) and swivel spray jet upwards out of cowl panel grille (arrow 2).
11. Adjust the wiper arm .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Checking actuation of heating element for additional heater Z35
• Removing and installing mobile telephone operating electronics control unit J412 (as of MY 04) · 2 torque figures
• Removing and installing sill panel trim (Allroad) – Audi A6 C5 · 1 torque figures
• Servicing wheel bearing housing with bolted wheel bearing
• Removing and installing hub carrier/wheel bearing housing (steel)