Removing and installing securing plates — AUDI

🧭 Before you start

Fits: VW Caddy IV (SA, 2015–2020)

Don't miss

• The bolts (1) and (3) are microencapsulated and must be renewed each time they are loosened.Before new bolts are installed, the threads of the corresponding holes must be cleaned.

📋 Procedure

1. Switch off ignition.
2. Remove floor covering .
3. Unscrew bolts (1) and remove securing plate (2) from vehicle.
4. Unscrew bolts (3) and remove securing strip (4) from vehicle. [Note: The bolts (1) and (3) are microencapsulated and must be renewed each time they are loosened.Before new bolts are installed, the threads of the corresponding holes must be cleaned.]
5. Remove remaining securing plates (qty. 4) and securing strips (qty. 3) as described.

6. Install securing plates (2) and securing strips (4).
7. Lightly tighten bolts (1) and (3)
8. Install seats in 1st row and check that they correctly lock into place.
9. Adapt seats in 1st row to fit in vehicle together with securing plates (2) and securing strips (4).
10. Remove 2nd row seats and tighten bolts (1) and (3).

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Renewing seal on right of bevel box - all wheel drive
• Removing and installing front brake cable
• Removing and installing protective sleeve for intermediate steering shaft
• Removing and installing parking aid control unit, vehicles up to model year 2010 · 1 torque figures
• Renewing oil seal for right flange shaft