Removing and installing seat trim (with height adjustment) — AUDI

🧭 Before you start

Fits: VW Caddy III (2K, 2004–2015); platform code 2C0

Don't miss

• For greater clarity, drawer is not shown in Figure.

📋 Procedure

1. Remove front seat .
2. Remove belt buckle
3. Lever latch (1) downwards from the side with 2 screwdrivers and pull drawer out of mounting. [Note: For greater clarity, drawer is not shown in Figure.]
4. Using a small screwdriver, lever the two covers (2) out of mountings in adjusting lever.
5. Undo and remove two bolts (3) and remove adjusting lever (4).

6. Unscrew bolts (5) and (6), and remove trim (7).
7. Undo and remove bolts (8) (Qty. 10).
8. Detach trim from seat frame.
9. Using assembly tool3399, acquire a grip on a detent behind backrest adjusting wheel (9).
10. Lever assembly tool3399 outwards (arrow A) and thus detach backrest adjusting wheel.
11. Detach trims (10) and (11) from mountings in seat frame.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing headlights (old headlight is fitted again)
• Removing and installing auxiliary relay carrier in electronics box (plenum chamber, right-side)
• Removing and installing relay and fuse holder in luggage compartment (right-side)
• Renewing flange shaft oil seal (left-side) with gearbox installed
• Removing and installing air filter element (left and right)