Removing and installing seat rail cover, split (Multivan from WEEK 45/2014) — AUDI

🧭 Before you start

Fits: VW Transporter T5 (7H), VW Transporter T5 (7J), VW Transporter T6 (7E), VW Transporter T6 (7F)

📋 Procedure

1. Insert screwdriver (2) in aluminium cover rail.
2. Release detent lug of cap (1) forwards in direction of (arrow a).
3. Remove cap (1) upwards in direction of (arrow b).
4. With both hands, grab the rubber lip of the aluminium cover rail (1).
5. Push aluminium cover rail (1) forwards in (direction of arrow).

6. Remove aluminium cover rail (1) straight upwards in (direction of arrow).
7. On opposite side, push aluminium cover rail forwards in same manner and remove it straight upwards.
8. Perform removal of aluminium cover rail on all seat rails.
9. Place aluminium cover rail (1) flush on rear cover rail (arrow).
10. Press aluminium cover rail (1) into clips of seat rail from above in (direction of arrow).
11. Place cap (1) from above on fastening ring (arrow).
12. Engage cap (1) downwards in (direction of arrow).

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Checking fuel pressure sender G247 – Audi A1 · 3 torque figures
• Adjusting vacuum unit for turbocharger – Audi A1
• Installing dual clutch – Audi A3
• Removing and installing engine mounting (right-side) – Audi
• Removing and installing coolant pipe (bottom left) – Audi