Removing and installing seat pan cover and padding, Transporter — AUDI

🧭 Before you start

Fits: platform codes SF, SG

Don't miss

• Instead of the 2 bolts 2 spreader rivets may be installed.
• The clamping washers are damaged during removal and must be renewed.

📋 Procedure

1. Switch off ignition.
2. Disconnect battery Electrical system27Battery; Disconnecting and connecting battery.
3. Remove bolts (4). [Note: Instead of the 2 bolts 2 spreader rivets may be installed.]
4. Remove bolts (2).
5. Lift up front seat padding until wiring harnesses are accessible.

6. Detach wiring harnesses from seat pan.
7. If fitted, disconnect connector of seat heating (3).
8. Remove front seat padding (1) from seat.
9. Fold out seat padding.
10. If fitted, disconnect connector.
11. Using a small screwdriver, lever off clamping washers (1). [Note: The clamping washers are damaged during removal and must be renewed.]
12. Remove washers (2).
13. Push seat padding with retaining bracket (3) towards left (arrow), and remove it upwards.
14. Installation is carried out in reverse order.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing windscreen: Exploded view
• Removing moulded headliner with sun roof
• Removing and installing electrical components with backrest
• Removing and installing motors and senders for height/longitudinal adjustment
• Removing and installing seat cover and upholstery