Removing and installing seat padding — AUDI

🧭 Before you start

Fits: platform codes 2EA, 2ED, 2EH, 2EX, 2EB, 2EE, 2EK, 2FC, 2FF, 2FL, 2FZ, 2FG, 2FM

Don't miss

• Separate electrical connector (if present) for seat heater.
• Ensure that the slides seat correctly in their guide.

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Remove seat .
2. Remove bolts (1) from seat frame (4)
3. Remove securing bracket with associated slides (2) and (3). [Note: Separate electrical connector (if present) for seat heater.]
4. Remove seat padding upwards.
5. Place seat padding on seat frame (4) from above.

6. Install securing bracket with slides (2) and (3).
7. Tighten bolts (1) to specified torque of 2.5 Nm. — 2.5 Nm (1.8 lb-ft)
8. Fit electrical wiring connector for seat heating (if fitted). [Note: Ensure that the slides seat correctly in their guide.]
9. Install seat .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing operating and display unit for Climatronic air conditioning system E87 with Climatronic control unit J255 (Caddy ► 2011) · 1 torque figures
• Removing and installing operating and display unit for Climatronic air conditioning system E87 with Climatronic control unit J255 (Caddy 2011►) · 1 torque figures
• Removing and installing "“radio and navigation system 2”" with multifunction display (MFD)
• Raising wheel suspension to unladen position
• Checking quantity injected