Removing and installing operating and display unit for Climatronic air conditioning system E87 with Climatronic control unit J255 (Caddy 2011►) — AUDI

🧭 Before you start

Fits: VW Caddy III (2K, 2004–2015); platform code 2C0

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Remove air conditioning system/heater control panel trim (Golf 2009 ►) 68.
2. Undo bolts (arrows) (1.5 ± 0.2 Nm) and remove operating and display unit for Climatronic air conditioning system E87 from dash panel. — 0.2 Nm (0.1 lb-ft)
3. Disconnect connectors on operating and display unit for Climatronic air conditioning system E87. [Note: If a new operating and display unit for Climatronic air conditioning system E87 with Climatronic control unit J255 is installed, the basic setting and an adaptation ("“Compressor first run”") must be carried out in the Guided Fault Finding or in the Guided Functions.]

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing air cleaner housing - vehicles with 4.2 ltr. FSI engine
• Removing and installing front parking aid warning buzzer H22 - 8-channel parking aid
• Removing and installing clutch pedal switch for engine start F194
• Removing and installing thermostat with hose connection – Audi
• Removing and installing rear Climatronic operating unit E265