Removing and installing operating and display unit for Climatic and air conditioning system with electric/manual controls — VW
Removing and installing operating and display unit for Climatic and air conditioning system with electric/manual controls on VW: 5 steps, 1 torque figure.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Polo 6R (2009–2014)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 0.2 Nm (0.1 lb-ft) | Remove bolts (2) (4.2 x 45) and (3) (4.2 x 16 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove dash panel middle trims General body repairs, interior68Storage compartments, covers and trims; Removing and installing dash panel middle trims.
- Remove bolts (1).
- Remove centre console cover General body repairs, interior68Removing and installing centre console cover.
- Detach connectors from Climatic heating regulation and air-conditioning system (2).
- Detach flexible shaft (1) for air distribution flap from Climatic heating regulation and air-conditioning system (2). [Note: When the flexible shaft (1) is installed, the actuator (2) and the rotary knob on the Climatic heating regulation and air-conditioning system must be aligned to one another in a specific position or the system will malfunction .The flexible shaft connexion (3) is referred to as "“terminal”".] [Note: When the flexible shaft (1) is installed, the actuator (2) and the rotary knob on the Climatic heating regulation and air-conditioning system must be aligned to one another in a specific position or the system will malfunction .]
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing rear section of reduction agent supply line
- Removing and installing front three-point seat belt, with belt end anchor tensioner · 1 torque figures
- Removing and installing J245sliding sunroof adjustment control unit · 1 torque figures
- Removing and installing rear axle, multi-link suspension, four-wheel drive
- Removing and installing spring, multi-link suspension, right spring for front-wheel drive
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.