Removing and installing seat height adjustment unit (seat with manual adjustment) — AUDI

🧭 Before you start

Fits: Audi TT Mk2 (8J, 2006–2014)

Don't miss

• Make sure electrical connectors are fitted correctly (as far as stop) and engage audibly.Make sure retaining plate (4) makes contact with outer backrest frame at point indicated by (arrow).
• If airbag warning lamp K75 indicates a fault following installation, you must interrogate, erase and then re-interrogate the fault memory .

📋 Procedure

1. ⚠ Observe safety regulations for pyrotechnic components .Before handling pyrotechnic components (e.g. unplugging the electrical connector) the mechanic must discharge any static electricity. This can be done by briefly touching the door striker plate, or similar. — Remove front seat .
2. Attach front seat to seat repair standVAS 6136.
3. Remove trim (sill side) .
4. Remove nut (3).
5. Remove bolts (5) (2x).

6. Remove bolt (2).
7. Detach seat height adjuster unit (1) and retaining plate (4). [Note: Make sure electrical connectors are fitted correctly (as far as stop) and engage audibly.Make sure retaining plate (4) makes contact with outer backrest frame at point indicated by (arrow).]
8. ⚠ Observe safety regulations for pyrotechnic components .Before handling pyrotechnic components (e.g. plugging in the electrical connector) the mechanic must discharge any static electricity. This can be done by briefly touching the door striker plate, or similar. — Switch on ignition.
9. ⚠ The battery must be connected with the ignition switched on. If pyrotechnic components (e.g. airbag or belt tensioner) are inexpertly repaired, this may result in unwanted triggering after connecting the battery. There must not be anyone in the vehicle while you are connecting the battery. — Connect battery earth wire with ignition switched on Electrical system27Battery; Disconnecting and connecting battery.
10. If airbag warning lamp K75 indicates a fault following installation, you must interrogate, erase and then re-interrogate the fault memory .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Checking fuel system pressurisation pump G6 (electrical test) - vehicles with 6-cylinder or 8-cylinder engine
• Measuring crankshaft radial clearance – Audi A8 D2 · 2 torque figures
• Separating centre and rear silencer · 2 torque figures
• Checking turbocharger and charge pressure regulating valve
• Automatic gearbox 09G — Exploded view - shift unit · 2 torque figures