Removing and installing seat height adjuster (seat with manual adjustment) — AUDI

🧭 Before you start

Fits: Audi TT Mk2 (8J, 2006–2014)

Don't miss

• Make sure seat height adjuster engages properly with fastener.
• Make sure springs (2) (2x) of retaining clip (3) are positioned on the outside of the lever (1).

📋 Procedure

1. Make improvised tool .
2. Pull seat height adjuster (1) as far upwards as possible and hold it in this position.
3. Carefully pull seat height adjuster (1) slightly off front seat.
4. Insert improvised tool (2) in mounting (4).
5. Pull improvised tool (2) in direction of (arrow B) and press spring of retaining clip outwards.

6. Detach seat height adjuster (1) from lever in direction of (arrow A).
7. Renew retaining clip at seat height adjuster lever, observing correct installation position of retaining clip .
8. Make sure seat height adjuster engages properly with fastener.
9. Bend a screwdriver (1) with a width (2) of 3.5 mm to dimensions:
10. Make sure springs (2) (2x) of retaining clip (3) are positioned on the outside of the lever (1).

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Servicing power-assisted steering box
• Checking wiring between "white" diagnostic connector and convertible top operation control unit -J256
• B - Removing and installing three-point B-pillar seat belt with mechanical belt tensioner
• Replacing engine electronics control unit – Audi 1.9 TDI 1Z
• Checking modulating piston movement sender -G149 and metering adjuster -N146