Removing and installing Bowden cable of seat height adjuster unit — AUDI

🧭 Before you start

Fits: Audi A4 Cabriolet B6/B7 (8H)

📋 Procedure

1. Remove seat (see the separate procedure).
2. Attach seat repair stand VAS 6136 to engine and gearbox support VAS 6095.
3. Attach front seat to seat repair stand VAS 6136.
4. Remove side trim (sill side) (see the separate procedure).
5. Remove side trim (tunnel side) (see the separate procedure).

6. Remove backrest (see the separate procedure).
7. Disengage Bowden cable (1) from retainer (2).
8. Disengage eyelet (4) from pin (3).
9. Disengage Bowden cable (1) from retainer (5).
10. Disengage hook (7) on Bowden cable from retainer (6).
11. Install Bowden cable of seat height adjuster unit (1) in reverse order of removal.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing rain and light sensor G397 - vehicles without humidity sender G355
• Removing and installing headlight housing - gas discharge headlights and LED headlights from model year 2015 onwards
• Removing and installing socket illumination bulb L42, 12 V socket U5
• Removing and installing aerial amplifier 2R111, Avant – Audi · 1 torque figures
• Removing and installing tiptronic switches in steering wheel E439/E438 · 1 torque figures