Removing and installing seat adjustment switch: Audi A6 C6

🧭 Before you start

Fits: Audi A6 C6 (4F, 2004–2011)

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Remove seat .
2. Attach seat repair standVAS 6136 to engine and gearbox supportVAS 6095.
3. Attach front seat to seat repair standVAS 6136.
4. Remove seat side trim (sill side) .
5. Unscrew bolts (5) (5x).
6. Detach seat adjustment switch (2).
7. Take out printed circuit board with connectors (1).

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing exhaust gas recirculation control motor V338 - engine codes CAMA, CAMB, CAPA
• Removing and installing alternator - vehicles with 2.0 ltr. TDI engine without SCR catalytic converter (PR number TH3 or TM4)
• Removing and installing starter - vehicles with 2.0 ltr. TDI engine (PR number TH3 or TM4)
• Exploded view - cylinder block (pulley end), vehicles with hydraulic power steering · 1 torque figures
• Removing and installing diagonal strut · 1 torque figures