Removing and installing seat: Audi A2

🧭 Before you start

Fits: Audi A2 (8Z)

• Special tools named: VAS 5094

Don't miss

• Before removing seat: Disconnect battery earth strap — Move seat forwards.
• Always keep to bolt installation sequence. — Screw in bolt (3) on tunnel side.
• Make sure there is no-one in the vehicle when connecting battery. — Connect battery.

📋 Procedure

1. ⚠ Before removing seat: Disconnect battery earth strap — Move seat forwards.
2. Remove seat console trim on tunnel side .
3. Remove seat console trim on sill panel side .
4. Unscrew bolts (2) (2x).
5. Move seat back.

6. Unscrew bolts (3) (2x).
7. Unplug connector on vehicles with heated seat.
8. Connect up airbag adapter VAS 5094.
9. Take seat out of vehicle.
10. Position seat in vehicle.
11. Remove airbag adapter VAS 5094.
12. Plug in connector on vehicles with heated seat.
13. ⚠ Always keep to bolt installation sequence. — Screw in bolt (3) on tunnel side.
14. Screw in bolt (3) on sill panel side.
15. Move seat forwards.
16. Screw in bolt (2) on tunnel side.
17. Screw in bolt (2) on sill panel side.
18. Switch on ignition.
19. ⚠ Make sure there is no-one in the vehicle when connecting battery. — Connect battery.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Checking throttle valve control part
• Checking exchange of data between control units
• Adaptation of throttle valve control unit
• Repairing clutch
• Testing air recirculation valve for turbocharger -N249