Removing and installing rotary knob for operating and display unit for camping equipment E153 — AUDI

🧭 Before you start

Fits: platform code SG

Don't miss

• If the trim of the rotary knob is damaged, it must be renewed as well.
• Make sure that the locking lugs are properly seated.
• By attaching the identification plate in this position, the component can be clearly identified as a repaired component.

📋 Procedure

1. Remove operating and display unit for camping equipment E153.
2. Carefully separate identification plate (1) using a suitable tool (2).
3. Use removal wedge3409 to press in locking lugs (1), and at the same time pull apart upper part (2) and lower part (3).
4. Fold upper part (1) 90° upwards.
5. Remove bolts (1).

6. Remove printed circuit board (2).
7. Pull off trim (2).
8. Pull off rotary knob (1).
9. If the trim of the rotary knob is damaged, it must be renewed as well.
10. Make sure that the locking lugs are properly seated.
11. Attach new identification plate (1) offset by approx. 0.5 cm (dimension a) relative to former position (2). [Note: By attaching the identification plate in this position, the component can be clearly identified as a repaired component.]

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing wiring harness with 14-pin connector
• Removing and installing fuel gauge sender 2G169 (left-side)
• Removing and installing electric radiator fan V7 – Audi AKF
• Removing and installing left exhaust manifold – Audi A8 D2
• Removing and installing CD changer R41/CD player R89 – Audi