Removing and installing right sliding door roller blind — AUDI

🧭 Before you start

Fits: platform code SG

📋 Procedure

1. Remove right B-pillar trim .
2. Remove right C-pillar trim .
3. Completely remove right roof side member trim (1).
4. Remove clamping pins for spreader rivets (2) on B-pillar using 3 mm hexagon key and then remove spreader rivets.
5. Unscrew bolt (3) for roller blind trim (1) on B-pillar.

6. Unscrew bolts (2) for roller blind trim (1) on C-pillar.
7. Lever roller blind with trims all around from sliding door seal beading.
8. Release roller blind (1) with trims (2) from B- and C-pillars, and remove it completely.
9. Insert roller blind with trims all around into sliding door seal beading.
10. Renew bolt (3) for roller blind trim (1) on B-pillar, and tighten it.
11. Renew bolts (2) for roller blind trim (1) on C-pillar, and tighten them.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing lateral acceleration sender, MY 2002> · 1 torque figures
• Vehicles with 1.9 l TDI unit injector engine
• Removing and installing track control link (all engine versions except 3.0 ltr. TDI and 3.2 ltr. FSI)
• Removing and installing brake caliper with brake carrier
• Adjusting locking cable (vehicles up to VIN 8E_6A156499) · 1 torque figures