Removing and installing remote positive terminal in plenum chamber - Audi RS 4 — AUDI

🧭 Before you start

Fits: Audi A4 B6/B7 (8E)

📋 Procedure

1. With ignition switched off, disconnect earth cable at battery .
2. Detach rubber seal of plenum chamber cover in direction of (arrow).
3. Remove plenum chamber cover (1) towards front.
4. Remove bolt (1).
5. Release retaining clip (2) in direction of (arrow A).

6. Detach remote positive terminal from mounting in direction of (arrow B).
7. Release retaining clip (arrow A) and open cover (2) over positive terminal.
8. Release cover (1) over electrical wiring in direction of (arrow B).
9. Unscrew nuts (1) and (4) at positive cables.
10. Remove remote positive terminal.
11. Connect battery. Steps required .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Checking delivery pressure of vane pump - Vehicles with 6-cyl. 5V engine
• Checking delivery of plunger pump - Vehicles with 4-cyl. engine
• Removing and installing roller rocker fingers – Audi A3
• Checking semi-automatic tensioning roller for toothed belt
• Removing and installing bracket for knee bolster on driver side (country-specific version)