Removing and installing bracket for knee bolster on driver side (country-specific version) — AUDI

🧭 Before you start

Fits: Audi A3 (8P, 2003–2012)

Don't miss

• Electrical connector (A) does not have to be unplugged.
• When turning left vent temperature sender G150 make sure that seal (C) is not pinched.

📋 Procedure

1. Remove storage compartment (driver side) (see the separate procedure).
2. Remove bolts (2) and (4).
3. Detach bracket for knee bolster from central tube (1).
4. Remove storage compartment (driver side) (see the separate procedure).
5. Remove left vent temperature sender G150.

6. Unscrew bolts (5), (6) and (8).
7. Remove wire retainer.
8. Detach bracket for knee bolster from central tube (1).
9. Turn left vent temperature sender G150(item B) 90° in direction of (arrow).
10. Remove left vent temperature sender G150 from air duct. [Note: Electrical connector (A) does not have to be unplugged.]
11. When turning left vent temperature sender G150 make sure that seal (C) is not pinched.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing intermediate flange - engine code letters BDG, BDH
• Removing and installing washer fluid reservoir - Audi RS 4
• Removing and installing navigation interface R94 (Avant) · 1 torque figures
• Removing and installing bearing for viscous fan in bracket - vehicles up to 05.2003
• Removing and installing radiator cowl - vehicles up to 10.2004