Removing and installing radiator cowl - vehicles up to 10.2004 — AUDI
Removing and installing radiator cowl - vehicles up to 10.2004 on Audi: 17 steps, engines AVB, AVF, AWX, BKE.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A4 Cabriolet B6/B7 (8H), Audi A4 B6/B7 (8E)
Don't miss
- Observe rules for cleanliness when working on automatic gearbox 00.
📋 Procedure
- Vehicles with auxiliary heater: remove bolts (arrows) securing exhaust pipe for auxiliary/additional heater to noise insulation.
- Release quick-release fasteners (1) and (2) and take off front noise insulation. Leave rear noise insulation in position.
- Remove bumper cover (front) 63.
- Move lock carrier to service position 50. [Note: Observe rules for cleanliness when working on automatic gearbox 00.]
- Place used oil collection and extraction unitV.A.G 1782 under engine.
- Remove ATF lines (top (arrow) and bottom) from radiator: 37.
- Tie ATF lines up onto longitudinal member to prevent fluid escaping.
- Seal off open pipes/lines and connections with clean plugs from engine bung setVAS 6122.
- If fitted, detach electrical connector (3) for radiator fan.
- Unbolt radiator fan control unit (2).
- Unplug electrical connector (1) at bonnet lock switch.
- Move wiring clear.
- Unscrew and remove radiator cowl (arrows).
- Secure ATF lines 37.
- Install lock carrier with attachments 50.
- Install bumper cover (front) 63.
- Check ATF level 37.
Other AUDI procedures
- Renewing O-rings for unit injector – Audi A3
- Removing and installing temperature sender after particulate filter G527 - vehicles with manual gearbox
- Checking compression - engine codes AVB, AVF and AWX – Audi
- Removing and installing intake manifold - engine codes AVB, AVF and AWX
- Removing and installing air mass meter G70 – Audi A6 C6
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.