Removing and installing relay and fuse holder BSB - vehicles up to 05.2009 — AUDI

🧭 Before you start

Fits: Audi A3 (8P, 2003–2012)

Don't miss

• Mark assignment of electrical wiring at screw connections for re-installation.

📋 Procedure

1. With ignition switched off, disconnect earth cable at battery .
2. Press clips in direction of (arrow) and remove cover for engine compartment electronics box.
3. Press both tabs in direction of (arrow) and remove cover for electronics box (engine compartment).
4. Mark assignment of electrical wiring at screw connections for re-installation.
5. Release retaining clip (2) and swivel wire retainer (1) to the side (arrow).

6. Unscrew nuts (3 ... 7) and pull electrical wires out of clamps.
7. Remove bolt (arrow).
8. Take relay and fuse holder BSB out of electronics box (engine compartment).
9. Fit relay and fuse holder BSB onto electronics box (engine compartment). Tighten securing bolt (centre); at the same time connectors will slide on.
10. Fit and secure electrical wiring to main fuse holder (electronics box in engine compartment) according to markings made earlier.
11. Connect battery. Steps required .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing selector lever cable on vehicles with 3.2 ltr. FSI engine with vehicle ID No. up to 8E_8A 002699
• Checking secondary air pump relay J299 and actuation
• Torque reaction support with valve for torque reaction support N382 - exploded view
• Checking ignition coils and output stages on vehicles with engine code "“AJK”", "“ARE”" and "“AZA”"
• Checking fuel cooling pump V166 - vehicles with engine code letters AJM