Removing and installing front passenger's footwell bracket for relay and fuse holder — AUDI

🧭 Before you start

Fits: platform code 42

📋 Procedure

1. Switch off ignition and take out ignition key.
2. Remove foot rest cover (front passenger's side) 70.
3. Remove dash panel cover (passenger's side) 68.
4. Cut through cable tie on manual release mechanism for front lid.
5. Cut through cable ties on wiring harnesses.

6. Remove nuts (3 and 4) and bolt (1).
7. Remove front passenger's footwell bracket (2) for relay and fuse holder in direction of (arrow).
8. Release retaining clips (arrows A) and lift onboard supply control unit J519(item 1) out of relay and fuse holder (arrow B).
9. Release retaining springs (arrows A) and remove onboard supply control unit J519 from relay and fuse holder towards left (arrow B).
10. Unclip fuse holders at relay carrier.
11. Detach relays and control units and then unclip appropriate relay carrier.
12. Install onboard supply control unit J519.
13. Install air duct for footwell vent 87.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing right centre vent control motor V111
• Removing and installing retainers for right control motors (with a "“Mix”" or "“High”" air conditioner)
• Removing and installing ATF lines – Audi A6/A7 C7
• Removing and installing timing chain cover (top left) – Audi
• Removing and installing seat ("High") - outer seats in 2nd row