Removing and installing rear parking aid warning buzzer — AUDI
Removing and installing rear parking aid warning buzzer on Audi: 5 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes 2EA, 2ED, 2EH, 2EX, 2EB, 2EE, 2EK, 2FC, 2FF, 2FL, 2FZ, 2FG, 2FM
Don't miss
- Unscrew securing bolt (arrow) on warning buzzer.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 2 Nm (1.5 lb-ft) | Tighten plastic screws |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Switch off ignition and all electrical loads, and pull out ignition key.
- Remove left front seat General body repairs, interior72Seat frames; Front seat; Removing and installing front seat with longitudinal adjustment.
- Unscrew securing bolt (arrow) on warning buzzer.
- Release and disconnect connectors.
- Remove warning buzzer.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing engine - R8 Spyder with manual gearbox/R tronic gearbox 086 · 1 torque figures
- Removing engine - R8 Coupé with manual gearbox/R tronic gearbox · 1 torque figures
- Removing engine - R8 Spyder with manual gearbox/R tronic gearbox · 1 torque figures
- Draining and replenishing coolant – Audi A8 D2 · 2 torque figures
- Audi 1.6 BAD gearbox removal & installation · 1 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.