Removing and installing parking aid warning buzzer H15: VW Polo 6R
Step-by-step removing and installing parking aid warning buzzer H15 for the VW Polo 6R: 5 steps, 1 torque figure.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Polo 6R (2009–2014)
Don't miss
- Detach spreader rivets (arrows) and remove rear parking aid warning buzzer H15.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 1 Nm (0.7 lb-ft) | Unscrew securing bolts (2 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Switch off ignition and remove ignition key.
- Remove rear right wheel housing trim General body repairs, interior68Removing and installing wheel housing trim (4-door vehicle).
- Remove rear right side trim panel General body repairs, interior70Removing and installing side trim panel.
- Disconnect connector (1).
- Detach spreader rivets (arrows) and remove rear parking aid warning buzzer H15.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Adjusting bonnet and striker pin · 2 torque figures
- Removing and installing lines for clutch mechanism – VW 2.0
- Removing and installing clutch pedal with over-centre spring, LHD
- Removing and installing drive shaft, constant velocity joint, threaded connection · 1 torque figures
- Removing and installing joint body – VW Polo 6C
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.