Removing and installing rear loudspeaker: Audi A4 Cabriolet B6/B7

🧭 Before you start

Fits: Audi A4 Cabriolet B6/B7 (8H)

• Special tools named: 3370

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Switch off all electrical equipment.
2. Remove ignition key.
3. Carefully pull trim (1) out of retaining clips at side trim (rear) using front-end hookVAS 3370.
4. Pry centre section of side trim (1) at top edge off side trim (rear) and remove it.
5. Unscrew bolts (arrows) (2 Nm). — 2 Nm (1.5 lb-ft)
6. Unplug electrical connector at loudspeaker, rear left R4(1).
7. Remove loudspeaker, rear left R4(1).
8. Installation is performed in reverse sequence.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Renewing front bonded rubber bushes in rear final drive carrier
• Removing and installing gas discharge bulb, headlights with gas discharge bulbs, vehicles up to 04.2011
• Removing and installing gas discharge bulb control unit, headlights with gas discharge bulbs, vehicles as of 05.2011
• Removing and installing seat belts of 3-person bench seat, Multivan
• Removing and installing belt buckles of 3-person bench seat, Transporter