Removing and installing rear left/rear right window regulator switch, in door E52/E54 — AUDI
Removing and installing rear left/rear right window regulator switch, in door E52/E54 on Audi: 11 steps.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A8 D3 (4E, 2002–2010)
📋 Procedure
- Switch off ignition and take out ignition key.
- Remove rear door trim 70.
- Detach insulating mat from door trim.
- Unscrew bolts (arrows) and detach armrest.
- Unscrew bolt (arrow) and detach switch mounting (1) from armrest.
- Unscrew bolts (arrows) and detach switch mounting with window regulator switch.
- Unplug electrical connector (2).
- Use small screwdriver to carefully release retaining hooks (arrows).
- Pull window regulator switch in rear door E52/E54(item 1) downwards out of switch mounting.
- Press switch into switch mounting until retaining hooks engage.
- Install rear door trim 70.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing left temperature flap control motor V158 / temperature flap control motor V68 · 1 torque figures
- Renewing oil seal together with sleeve (one-piece sleeve and flange shaft oil seal (right-side))
- Adjusting engine mountings – Audi A3
- Removing and installing clutch pedal
- Removing and installing gearbox support – Audi A3
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.