Adjusting door window — AUDI
Adjusting door window on Audi: 13 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform code FV
Don't miss
- The height adjuster screw is accessible through the hole at the bottom edge of the door; it is not necessary to remove the door trim.
- The stop bolt is accessible through the hole at the bottom edge of the door; it is not necessary to remove the door trim.
- The top edge of the window moves in the opposite direction to the stop.
📋 Procedure
- Pull off plug (3) at bottom of inside section of door. [Note: The height adjuster screw is accessible through the hole at the bottom edge of the door; it is not necessary to remove the door trim.]
- For height adjustment, use Allen key, long reach T10058 to turn adjuster screw (arrow).
- Pull off plug (2) at bottom of inside section of door. [Note: The height adjuster screw is accessible through the hole at the bottom edge of the door; it is not necessary to remove the door trim.]
- For height adjustment, use Allen key, long reach T10058 to turn adjuster screw (arrow).
- Remove door trim General body repairs, interior70Door trim (front); Removing and installing door trim (front).
- Pull off plug (arrow) on inside section of door.
- Loosen nut (2).
- For lateral adjustment, use screwdriver Torx T25T10248 to adjust pin (1).
- Re-tighten nut.
- Pull off plug (1) at bottom of inside section of door. [Note: The stop bolt is accessible through the hole at the bottom edge of the door; it is not necessary to remove the door trim.]
- Loosen nut (1).
- For adjustment, use screwdriver Torx T25T10248 to adjust adjuster screw (2). [Note: The top edge of the window moves in the opposite direction to the stop.]
- Re-tighten nut.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing sealing flange on pulley end
- Renewing right oil seal
- Removing and installing subframe with hydraulic steering rack
- Removing and installing filler pipe for washer fluid reservoir · 2 torque figures
- Removing and installing front left vehicle level sender G78, headlights with gas discharge lamps and cornering lights · 2 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.